BMFabrications Arctic Cat / Yamaha Pro Climb/ Pro Cross / Snowmobile Ascender Boards

Description

2012 - 2019 Pro Climb/Pro Cross/Ascender/ALPHA/Viper chassis snowmobiles
Direct fit to the 2017+ Mountain Cat/ Alpha Snowmobiles

-Will use factory mounting locations (Covers factory rear outer rail hole in the tunnel)
-Front of boards foot holes pushed as far forward as possible
-Front hoops that go vertical with no swing toward the outside to allow panels to be pushed further in
-6 1/4 width at front of boards (One inch narrower on each side on the 12-16 Pro Climb Chassis)
-outer edge angled at least 1" higher than stock height

B&M Fabrications Burly Boards were designed for the rider that demands the best. Our boards feature a unique trellis pattern that provides strength, great looks, and superior snow shedding capabilities. This design allows for a better response to rider input by eliminating the "flex" of stock running boards.

Features:

•  Made of 6000 series Aluminum

•  Inner rail/Inside tubing- 3/4" x 1/8"wall

•  Outer rail- 1" x 1/8" Wall

•  "The Original Gold Screw" Traction Screws

•  Powder Coated for long-lasting finish and durability

Note:

Requires cutting of factory running boards. Please download our install directions if you are unsure of your capabilities.

Traction screws are to be installed by the customer.

All hardware and rivets are included.